Docker Standalone

💡 Tip

The easiest way to run SigNoz is to use SigNoz Cloud - no installation, maintenance, or scaling needed.

New users get 30 days of unlimited access to all features. Click here to sign up.

Once you have successfully installed SigNoz on Docker Standalone, the following sections provide an overview of the activities that are required to successfully operate SigNoz.

Stop/Start SigNoz Cluster

To stop SigNoz cluster:

docker compose -f docker/clickhouse-setup/docker-compose.yaml stop

To start/resume SigNoz cluster:

docker compose -f docker/clickhouse-setup/docker-compose.yaml up -d
📝 Note

The stopped SigNoz cluster should resume and mount to the existing docker volumes.

Upgrade SigNoz Cluster

Use the commands below to sync to the latest release.

  1. Checkout to main branch:

    git checkout main
    
  2. Pull the latest changes from the SigNoz GitHub repository:

    git pull origin main
    
  3. Go to deploy folder and run the install.sh script:

    cd deploy && ./install.sh
    

In case you wish to upgrade the SigNoz cluster to a specific version, let's say v0.6.2, follow the steps below:

  1. Checkout to the v0.6.2 tag:

    git checkout v0.6.2
    
  2. Go to deploy folder and run the install.sh script:

    cd deploy && ./install.sh
    
⚠️ Warning
  • Be careful with breaking changes across versions!
  • There might be misconfiguration caused by version mismatch.

Uninstall SigNoz Cluster

Enter the following command to uninstall SigNoz:

docker compose -f docker/clickhouse-setup/docker-compose.yaml down -v

Remove the Sample Application from SigNoz Dashboard

Follow the steps in this section to remove the sample application that comes installed with SigNoz:

  1. From the directory in which you installed SigNoz, open Docker Compose file deploy/docker/clickhouse-setup/docker-compose.yaml in a plain-text editor.

  2. Comment out or remove the services.hotrod and services.load-hotrod sections:

Remove the sample application on Docker Standalone
  1. Move into the deploy directory and run the install.sh script again:

    cd deploy && ./install.sh
    
📝 Note

If you still see the HotROD services on the dashboard, just wait for a few minutes and the changes will reflect.

Was this page helpful?